*Workaround*: This appears to occur when collocated nodes are running at high power. Apparently the baseband signal of the chip may be getting detected at times and reported to random channels. Since this situation does not cause any RF issues it can be ignored, or you can shield or reduce power on the devices to remove the bogus entries from the scan list.
Issue #142: Changing MESH RF IP Address does not change the corresponding DTD IP address.
*Workaround*: No workaround at this time.
Issue #49: When a foreign network is attached to the WAN of a mesh node, routing will fail when this network is down.
*Workaround*: When "Allow others to use my WAN" is enabled, LAN devices and other mesh nodes will continue attempting to route to this down network even though it is unreachable. No workaround at this time.
Issue #41: MikroTik devices not linking over RF on 5MHz channel width.
*Workaround*: Some models of Mikrotik 2GHz equipment can link with each other but not with other vendor equipment when using 5MHz channel width. This is apparently a hardware issue and can be avoided by using 10MHz channel widths.