diff --git a/arednGettingStarted/node_status.rst b/arednGettingStarted/node_status.rst index 7fa8ab8..e57aab9 100644 --- a/arednGettingStarted/node_status.rst +++ b/arednGettingStarted/node_status.rst @@ -36,7 +36,7 @@ Select Theme Node Settings Summary --------------------- -The area under the display buttons shows both configuration and network status information. The left column contains the IP address and gateway details for the network interfaces on this node, as well as the SSID, channel, and channel width settings if Mesh RF is enabled. If WAN Wifi Client is enabled it will also show the SSID and signal strength to the connected Wifi Access Point. +The area under the display buttons shows both configuration and network status information. The left column contains the IP address and gateway details for the network interfaces on this node, as well as the SSID, channel, and channel width settings if Mesh RF is enabled. If WAN Wifi Client is enabled it will also show the SSID and signal strength to the connected Access Point. If LAN AP is enabled then the LAN AP SSID will also be displayed. The right column contains the Signal Strength readings and other attributes of your node. The **signal / noise / ratio** shows the strongest neighbor signal strength in :abbr:`dBm (decibels relative to one milliwatt)` from all connected stations, and it is available only when the node is connected to a neighbor node via :abbr:`RF (Radio Frequency)`. Click these links for further information about `Signal to Noise Ratio `_ and values measured in `decibels `_. There are many factors that impact the network throughput you can expect to achieve, but as a general rule the higher the Signal-to-Noise ratio the better the throughput for your RF links.