From cf7b9b3ae692aa4b183b2d169218b71c7bcd8dac Mon Sep 17 00:00:00 2001 From: Mark Qvist Date: Wed, 20 Jun 2018 22:01:24 +0200 Subject: [PATCH] Updated readme --- README.md | 3 +-- 1 file changed, 1 insertion(+), 2 deletions(-) diff --git a/README.md b/README.md index 777eb49..e67b5f3 100644 --- a/README.md +++ b/README.md @@ -1,6 +1,5 @@ # RNode Firmware -## Intro This is the firmware for RNode, a very flexible LoRa-based communication device. RNode can functions as a: - Network adapter for [RNS](https://github.com/markqvist/Reticulum) @@ -29,7 +28,7 @@ RNode can operate in two modes, host-controlled (default) and TNC mode: ## USB and Serial Protocol You can communicate with RNode either via the on-board USB connector, or using the serial pins on the board (labeled RX0 and TX0). RNode uses a standard FTDI USB chip, so it works out of the box without additional drivers in most operating systems. -All communications to and from the board uses [KISS framing](https://en.wikipedia.org/wiki/KISS_(TNC)) with a custom command set. RNode also does not use HDLC ports in the command byte, and as such uses the full 8 bits of the command bytes for the actual command. Please see table below for supported commands. +All communications to and from the board uses [KISS framing](https://en.wikipedia.org/wiki/KISS_(TNC)) with a custom command set. RNode also does not use HDLC ports in the command byte, and as such uses the full 8 bits of the command byte is available for the actual command. Please see table below for supported commands. | Command | Byte | Description | -----------------|------| -----------------------------------------------