aredn/files
Conrad Lara - KG6JEI bb83809472 hardware: Testing support for CPE210 v1.1
Add board definition for CPE210 v1.1 in testing mode.

{{{
 ========== iw phy phy0 info ==========
 Wiphy phy0
	max # scan SSIDs: 4
	max scan IEs length: 2257 bytes
	max # sched scan SSIDs: 0
	max # match sets: 0
	Retry short limit: 7
	Retry long limit: 4
	Coverage class: 9 (up to 4050m)
	Device supports AP-side u-APSD.
	Device supports T-DLS.
	Available Antennas: TX 0x3 RX 0x3
	Configured Antennas: TX 0x3 RX 0x3
	Supported interface modes:
		 * IBSS
		 * managed
		 * AP
		 * AP/VLAN
		 * WDS
		 * monitor
		 * mesh point
		 * P2P-client
		 * P2P-GO
		 * outside context of a BSS
	Band 1:
		Capabilities: 0x11ef
			RX LDPC
			HT20/HT40
			SM Power Save disabled
			RX HT20 SGI
			RX HT40 SGI
			TX STBC
			RX STBC 1-stream
			Max AMSDU length: 3839 bytes
			DSSS/CCK HT40
		Maximum RX AMPDU length 65535 bytes (exponent: 0x003)
		Minimum RX AMPDU time spacing: 8 usec (0x06)
		HT TX/RX MCS rate indexes supported: 0-15
		Frequencies:
			* 2397 MHz [-2] (30.0 dBm)  <-- This is kernel fallback when channel is
			* 2402 MHz [-1] (30.0 dBm)  <-- not defined in radio EEPROM, set to 22 instead
			* 2412 MHz [1] (22.0 dBm)
			* 2417 MHz [2] (23.0 dBm)
			* 2422 MHz [3] (23.0 dBm)
			* 2427 MHz [4] (23.0 dBm)
			* 2432 MHz [5] (23.0 dBm)
			* 2437 MHz [6] (23.0 dBm)
			* 2442 MHz [7] (23.0 dBm)
			* 2447 MHz [8] (23.0 dBm)
			* 2452 MHz [9] (23.0 dBm)
			* 2457 MHz [10] (23.0 dBm)
			* 2462 MHz [11] (23.0 dBm)
			* 2467 MHz [12] (30.0 dBm)  <-- This is also kernel fallback
			* 2472 MHz [13] (30.0 dBm)  <-- Set to 23 instead as that was was above
			* 2484 MHz [14] (30.0 dBm)
	valid interface combinations:
		 * #{ managed } <= 2048, #{ AP, mesh point } <= 8, #{ P2P-client, P2P-GO } <= 1, #{ IBSS } <= 1,
		   total <= 2048, #channels <= 1, STA/AP BI must match, radar detect widths: { 20 MHz (no HT), 20 MHz, 40 MHz }
		 * #{ WDS } <= 2048,
		   total <= 2048, #channels <= 1, STA/AP BI must match
	HT Capability overrides:
		 * MCS: ff ff ff ff ff ff ff ff ff ff
		 * maximum A-MSDU length
		 * supported channel width
		 * short GI for 40 MHz
		 * max A-MPDU length exponent
		 * min MPDU start spacing
}}}

ref AREDN->ticket:183

Change-Id: I00e52b80ce5f8e8a774c7bae7d946a6dab73bacf
2016-09-18 17:49:46 +00:00
..
etc enable leafletjs, leafletcss, and maptiles to be based on uci config vars 2016-06-22 08:43:28 -05:00
lib/upgrade/keep.d feature: added vtun config files to keep list during sys upgrade 2015-04-09 11:10:09 -05:00
usr add initial AREDN lua libraries 2016-09-07 02:26:55 +00:00
www hardware: Testing support for CPE210 v1.1 2016-09-18 17:49:46 +00:00