bugfix: Remove references to WRT54*'s

files/www/help.html

@@ -279,11 +279,10 @@ In the <strong>WiFi</strong> box there are settings shown as being
 Active Settings. These settings can be changed without rebooting the node by
 clicking the <strong>Apply</strong> button, but unless they are saved they
 will revert to the previously saved values after a reboot.<br> <br>
-The <strong>Rx Antenna</strong> and <strong>Tx Antenna</strong> settings of
-Right and Left are from the point of view from the front of the router. This
-is valid for the WRT54GL, but it is not unreasonable to expect that they may
-be reversed for some other router models. If you find this to be the case,
-contact the webmaster and it will be accounted for in the firmware.
+The <strong>Rx Antenna</strong> and <strong>Tx Antenna</strong> settings are
+named to match either the printed name on the antenna connector or in the
+case of units that have a built in antenna the names are for units mounted
+in its normal orientation.
 </p>
 <p>
 The <strong>Distance</strong> setting adjusts the packet retry timer
@@ -699,12 +698,13 @@ How to use failsafe mode:
 Now power cycle the node and it should accept your new password.
 </p>
 <p>
-But be warned, I have a version 2 wrt54g for which this method does not
-work. Currently it is the only model I am aware of which does not work. If it
-doesn't work, you are Simply Outta Luck unless you can get someone with an
-authorized ssh key to log in to the node and help you. Failing that, your last
-resort is to use the <a href='#tftp'>tftp method</a> described in a separate
-article to reinstall the firmware.
+If the device has a reset button you may instead press and hold the reset
+button for 15 seconds which will cause the unit to behave as if it had
+just been flashed with the AREDN&trade; firmware.
+</p>
+<p>
+You would need to go through the node settings again just as if it was
+the first time installing the AREDN&trade; firmware on the node.
 </p>
 
 <br><hr width=500><br>