2.0 KiB

Raw Blame History

Bolt AR-15 Lower Reciever

Author

RollaTroll

Version

1.0

Description

The Gauntlet has been thrown down and the 3dprinting faculty, FOSSCAD, has answered with this lower receiver you don't need to 3dprint but you TOTALLY CAN :D!

Provided are 2 sets of files, denoted by 'Original' or 'Reinforced'. The Original parts in this folder can be used to mill or cut out a lower receiver and should NOT be used to make a 3dprinted lower receiver.

AGAIN, ORIGINAL FILES ARE NOT MEANT TO BE PRINTED.

The Reinforced parts were designed for printing. Original and Reinforced parts do not mix.

Also provided are DWG files which are popular with laster cutting. The left and right sides should be fully cuttable while other files have been provided for reference. ALL Bolt files should be used at the operators discretion and own risk.

Instructions:

All hardware M3 sized.

Nut x15
10mm x6
30mm X5
25mm X2
50mm X2

Print/make 1 of all:

Buffer tower should be printed flat, perpendicular to the print bed, as if the stock were vertical,
Grip part should be printed on its side.
Mag well front should be printed with the pivot holes away from the print bed so that the face that is profiled for the mag well is against the print bed.
Mag well back should be printed with the largest flat side against the print bed. This is the side opposite the mag well.
Both mag well sides should be printed on their largest flat face, the side opposite the mag well.
Both left and right (rear) sides should be printed with the internal facing (flattest) sides against the print bed.
Fire control well bottom should be printed flat, so the side facing the trigger guard is against the print bed.
Trigger guard can be printed either flat (so it looks like a bridge), or on its side (so it needs no support).

Please come to FOSSCAD's IRC channel, http://fosscad.org/chat. if you have any questions. We are on OFTC in #fosscad.

2.0 KiB Raw Blame History